Panasonic Viera TX-P42VT30E Operating Instructions Manual page 13

[WPS(Push button)]
6
1. Press the WPS button on the access point until the light flashes
2. Connect the Wireless LAN Adaptor and the access point
WPS(Push button)
1) Please press the 'WPS' button on the access
point until its light flashes.
2) When the light is flashing select 'Connect' on
TV.
If you are unsure, please check the instruction
manual of the access point.
3. After the access point setting is finished, perform the connection test
4. Go to the next step
(Press twice)
Select [Home]
7
Select [Home] viewing environment to use in your home environment.
Please select your viewing environment.
Home
■
[Shop] viewing environment (for shop display only)
[Shop] viewing environment is the demonstration mode to explain main features of this TV.
Select [Home] viewing environment to use in your home environment.
•
You can return to viewing environment selection screen at the stage of Shop confirmation screen and Automatic
Demo Off / On selection screen.
1
Return to viewing environment selection
screen
Shop
You have selected shop mode
Automatic Demo
Off
To change viewing environment later on, you will need to initialise all settings by accessing Shipping Condition.
[Shipping Condition] (p. 27)
Auto Setup is now complete and your TV is ready for viewing.
If tuning has failed, check the connection of the satellite cable, RF cable, and then, follow the on screen instructions.
•
To retune all channels
•
To add the available TV mode later
•
To initialise all settings
Do not display a still picture for a long time
This causes the image to remain on the plasma screen ("image retention"). This is not considered a malfunction and is not
covered by the warranty.
Typical still images :
•
Channel number and other logos
•
Image displayed in 4:3 mode
•
Video game
•
Computer image
To prevent image retention, contrast is lowered automatically after a few minutes if no signals are sent or no operations are
performed.
Connect
Connection Test
Check access point connection.
Check acquired IP address.
Check for devices using same IP address.
Check gateway connection.
Check server connection.
7
Shop
On
[Auto Setup] (p. 25, 26)
[Add TV Signal] (p. 25, 26)
[Shipping Condition] (p. 27)
•
Ensure that your access point supports WPS for this setup.
•
WPS : Wi-Fi Protected Setup™
•
If the connection has failed, check the settings and positions of your
access point. And then, follow the on screen instructions.
: succeeded
The test is successful and the TV is connected to the
network.
: failed
Check the settings and connections. And then select
[Retry].
•
To set manually, select [Manual] and set each item.
select
set
2
Select [Home]
Please select your viewing environment.
Home Shop
select
set
13