Table of Contents
Advertisement
Introduction
To perform most repairs, the unit must be
disassembled in order to gain access to the
various internal components. Reasonable
care should be taken in order to avoid
damaging or stressing the housing and
internal components. Motorola recommends
the use of a properly grounded high imped-
ance
conductive
performing any of these procedures.
CAUTION
Many of the integrated circuit
devices used in this equipment
are vulnerable to damage from
static charges.
wrist band, connected to an
anti-static
(conductive)
surface, must be worn during all
phases of disassembly, repair,
and reassembly.
wrist
strap
while
An anti-static
work
Motorola Confidential Proprietary
Disassembly
Recommended Tools
The following tools are recommended for
use during the disassembly and reassembly
of the StarTAC.
¥ Anti-Static
Mat
includes:
Ñ Anti-Static Mat 66-80387A959
Ñ Ground Cord 66-80387A989
Ñ Wrist Band 42-80385A59
¥ Plastic Prying Tool SLN7223A
¥ Antenna Tool SYN5179A
¥ Tweezers
¥ Disassembly Fixture 8185677C02
Transceiver Disassembly
The preferred method for transceiver disas-
sembly is using the disassembly fixture.
Refer to page 17 for step by step instruc-
tions on using the disassembly fixture.
NOTE
Service
personnel
familiar with all of the following
information before attempting
unit disassembly.
Kit
(RPX-4307A);
should
be
55
Advertisement
Table of Contents
