Advertisement
965101
FLAT & INCLINE BENCH ASSEMBLY INSTRUCTIONS
1.
Slide one (1) 7/]L6 ~ X 4 ~ ~ C~ onto ~e 6-1/8 X 3-7/8 ~ U-P~ ~d proceed to am;emble it
~e
BENC~ FR~ ~LD~NT
~ sho~
on
~w~g.
Insert two (2) 3 X 2 INSERT GUIDES into each end of the ADJ SLEEVE WELDMENT
as .,;hoxvn
drawing.
(NOTE: MAKE SURE THE INSERT GUIDES S NAP INTO THE HOLES OF THE
WELDMENT).. SECURELY assemble
the SPRING PIN ASSEMBLY to the ADJ SLEEVE
WELDMENT as shown in (DETAIL A).
Pull back the SPR.ING PIN on the ADJ SLEEVE WELDMENT
and slide it over the end of ~ae BENCH
FRAME WELDMENT
,as shown on drawing. Slide WELDMENT
up to the f'ast adjustmenl ~. hole
underneath.
o
Insert three (3)'3 X 2 IN END CAPS into the ends of the REAR UPRIGHT WELDMENT
a:; shown
drawing.
SECURELY a.~;semble
the REAR UPRIGHT WELDMENT to the
BENCH FRAME WELDMENT as
shown on drawing.
Assemble the LEFT and RIGHT BACK PAD ANGLE WELDMENTS, along with two (2) HINGE
TABS to the BENCH FRAME WELDMENT as shown on drawing.
(NOTE: TIGHTEN
CONNECTION ENOUGH TO REMOVE TIlE
PLAY YET ALLOWING THE PARTS TO
ROTATE FREELY).
7°
Assemble t~vo (2) 1/2 X 2 X 15-1/2 IN PLATES to the inside of the LEFT and RIGHT BACK PAD
ANGLE WEL'I)MENTS as shown on drawing.
('NOTE: TIGHTEN CONNECTION ENOUGH
REMOVE "lille
PLAY ~rET ALLOWING THE PARTS TO ROTATE FREELY).
Rotate the LEFT and RIGHT BACK PAD ANGLE WELDMENTS
up and assemble the 1/2 X 2 X 15-
1/2 IN PLATES to the ADJ SLEEVE WELDMENT as shown on drawing.
(NOTE: DO NOT OVER
TIGHTEN TI]~S
CONNECTION).
Part # 6653501
3
Revision: 11/26/96
Advertisement
