Storage - Ariens 911207 - Pro21XD, 911214 - Pro21XD CARB Owner's/Operator's Manual

Walk behind lawn mower
Table of Contents

Advertisement

To adjust:
1. Move the wheel drive cable adjuster up
or down the handlebar. See Figure 24.
To increase traction and speed, move
the cable adjuster down the handlebar.
To decrease traction and speed, move
the cable adjuster up the handlebar.
2. Check the adjustment and readjust as
needed.
CAUTION: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
IMPORTANT: NEVER spray unit with high-
pressure water or store unit outdoors. Store
mower in a cool, dry, protected location.
Cleaning
Allow unit to cool. Clean unit thoroughly with
mild soap and low pressure water. Brush off
dirt and debris from all surfaces. Touch up all
scratched surfaces to prevent rust. Matching
touch-up paint is available from your Ariens
Dealer. Do not use abrasives, solvents, or
harsh cleaners.
Cable Adjuster

STORAGE

Inspection
Inspect mower and repair or replace worn or
damaged parts to avoid delays when
beginning use again.
Regularly check all hardware and keep
fasteners tight. Know unit is in safe working
condition.
Grass Bag
Wash out grass bag and allow to dry before
storage. Grass bag may be stored in position
on mower.
Engine
Close fuel shutoff valve.
When storing unit for extended periods of
time, remove all fuel from tank and carburetor
(run dry). Refer to engine manual.
GB - 22
Figure 24

Advertisement

Table of Contents
loading

Table of Contents

Save PDF