Flavel Calibre FBFC**MN2 Installation, Maintenance & User Instructions page 32

3.9.2 Thermostatic mode
PLEASE NOTE : Thermostatic mode of this fire will only allow
regulation of the room temperature by the fire when it has
been already lit via manual operation of the handset. It will not
allow the fire to light automatically due to low ambient room
temperature and should therefore not be relied upon for frost
protection purposes.
3.9.2.1 Hold the handset with one hand ensuring your hand is wrapped around
the back and that your hand is in contact with both sides of the handset.
The green light of the "unlock" symbol should light.
3.9.2.2 With the handset held as described above, press and release the mode
button several times as necessary until the display has the thermometer
symbol flashing at the top of the display. Press the set button to enter
this mode, as shown below in figure 30.
Fig. 30
- button
3.9.2.3 Press the set button again to see the temperature setting that is set (the
default is 24 degrees celsius). If a different set temperature is required,
whilst the display is showing this set temperature, press the + and -
buttons to alter this setting, press the set button to store the required
temperature, or alternatively the handset can be left for a few seconds
and the temperature will be stored automatically.
32
Thermostatic model symbol
+ button