Elo TouchSystems ESY10i1 User Manual page 27

operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement."
FCC RF Exposure Compliance: This equipment complies with radio frequency (RF) exposure
limits adopted by the Federal Communications Commission for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20 cm between the
radiator & your body.
IC RF Exposure Compliance: This equipment complies with IC RSS-102 RF exposure limits set
forth for an uncontrolled environment. This equipment should be installed and operated with
minimum distance 20 cm between the radiator & your body.
Déclaration d'exposition aux radiations: Cet équipement est conforme aux limites d'exposition
aux rayonnements IC établies pour un environnement non contrôlé. Cet équipement doit être
installé et utilisé avec un minimum de 20 cm de distance entre la source de rayonnement et
votre corps.
Notice to Users in the European Union: Use only the provided power cords and
interconnecting cabling provided with the equipment. Substitution of provided cords and
cabling may compromise electrical safety or CE Mark Certification for emissions or immunity
as required by the following standards:
CE RF Exposure Compliance: This device meets the EU requirements (1999/519/EC) and the
International Commission on Non-Ionizing Radiation Protection (ICNIRP) on the limitation of
exposure of the general public to electromagnetic fields by way of health protection.
General Information to all Users: This equipment should be installed and operated with
minimum distance 20 cm between the radiator & your body.
This Information Technology Equipment (ITE) is required to have a CE Mark on the
Manufacturer's label which means that the equipment has been tested to the following
Directives and Standards: This equipment has been tested to the requirements for the CE
Mark as required by EMC Directive 2004/108/EC as indicated in European Standard EN
55022 Class A and the Low Voltage Directive 2006/95/EC as indicated in European Standard
EN 60950-1.
General Information to all Users: This equipment generates, uses and can radiate radio
frequency energy. If not installed and used according to this manual the equipment may cause
User Manual: i-Series Interactive Signage
SW602242 Rev B, Page 27 of 31