Elo TouchSystems ESY10i1 User Manual page 21

3.1.2. GPIOs
 pullHighGPIO
 Pull high the state of
 PullLowGPIO
 Pull low the state of
 getGPIOInterfaces
 Get the list string data of interest GPIOs at designed system.
 Refer to Table 3-1 GPIOs list
 Note:
 The pull action only workable with output pin defined GPIO
 The input pin defined GPIO can notify the application about the status change by
"ELOPeripheralEventListener" also
3.1.3. IDLE
 activeIdleMode
 Force system to enter IDLE_MODE (IDLE_MODE on)
 disactiveIdleMode
 Force system to leave IDLE_MODE (IDLE_MODE off)
3.2. ELOPeripheralEventListener
GPIO-iface
GPIO-iface disactiveBCR
GPIOs
gpio80
gpio81
gpio82
Table 3-1 GPIOs List
PIN define
Output
Input
Input
User Manual: i-Series Interactive Signage
SW602242 Rev B, Page 21 of 31