Table of Contents
Advertisement
1.2
S
ETUP
Read the Operation Manual before setting up the Recumbent Lifecycle Exercise Bike.
E
P
LECTRICAL
OWER
The Recumbent Lifecycle Exercise Bike with the Engage
the electrical configurations listed in the chart below. External power is optional with the Inspire
the Achieve
Console (LED).
TM
NOTE: Do not modify the plug provided with this product. If the plug does not fit into an available electrical outlet, have a prop-
er outlet installed by a qualified electrician.
W
P
HERE TO
LACE THE
Following all safety instructions in Section 1.1, move the bike to the location in which it will be used. See Section 3, titled
Specifications, for the dimensions of the product footprint (assembled dimensions). Allow a distance of 8 to 12 inches, or 21
to 30 centimeters, between the bike and other objects or surfaces on either side. Allow a distance of 3 feet, or 1 meter, from
the front or rear of the bike to any other object or surface.
H
S
OW TO
TABILIZE THE
After placing the bike in position, check the unit's stability by attempting to rock it from side to side. Any slight rocking
indicates that the unit must be leveled. Determine which foot is not resting completely on the floor. Loosen the jam nut
(A) with an open-end M17 wrench, and rotate the stabilizing foot (B) to lower it. Verify that the bike is stable, and repeat
the adjustment as necessary until the unit no longer rocks. Lock the adjustment by tightening the jam nut against the
stabilizer bar.
C
B
HECK FOR
ATTERY
The Achieve (LED) and Inspire (7" LCD) consoles are powered by a rechargeable 6-volt battery. Check the battery by
pressing and holding the power on/off
Achieve console will display a prompt to set up a workout. The Inspire console will show a message on the LCD indicat-
ing it is initializing (for up to 2 minutes). If a prompt doesn't appear or initializing doesn't begin, mount the Recumbent
Lifecycle Exercise Bike and begin pedaling. The console should light up and programming a workout should be possible.
Pedal for 20 minutes at 40 rpm or faster during a workout to charge the battery. The pedal action during workouts keeps the
battery charged. If the Lifecycle Exercise Bike is externally powered by the 36V DC power supply, battery maintenance is auto-
matic and pedaling is not required.
R
EQUIREMENTS
Supply Voltage
(VAC)
100
110
120
200
220
230
240
R
L
ECUMBENT
IFECYCLE
R
L
ECUMBENT
IFECYCLE
A
P
OWER
key. The console should beep and light up. The Message Center on the
Console (15" LCD) requires an AC power supply according to
TM
Frequency
Rated Current
(Hz)
(Amps)
50 / 60
1.6
50 / 60
1.6
50 / 60
1.6
50 / 60
.8
50 / 60
.8
50 / 60
.8
50 / 60
.8
®
E
B
XERCISE
IKE
®
E
B
XERCISE
IKE
B
Console (7" LCD) and
TM
7
Advertisement
Table of Contents
Troubleshooting
