Setup And Initialization - ActiGraph GT9X Link + ActiLife Quick Start Manual

Setup and Initialization

1
2
3
4
6
Open the ActiLife software.
Connect the ActiGraph Link to the PC using the Link dock. The monitor will appear in the grid under the
'Devices' tab.
Select 'Initialize'. A submenu will open to display several initialization options.
Select 'Regular Initialization' from the submenu. A dialog box will open to display the initialization parameters
listed below. The most commonly used initialization parameters are pre-selected as system defaults.
Start and Stop Times
Enter the dates and times when the device should start and stop collecting data. If no start time is
selected, the system defaults to two minutes ahead. If no stop time is selected, the device will continue
to collect data until the battery is depleted, the memory capacity is full, or it is downloaded and
reinitialized.
Device Time
Set device to local computer time or atomic time.
Sample Rate
Select the device sampling rate ranging from 30 to 100 Hz. Note that higher sampling rates will result in
reduced device storage capacity and battery life.
actigraphcorp.com