Advertisement
Deployment & Information for Subjects
2
Wearing the ActiGraph Link
The ActiGraph Link will typically be worn at the waist or on the non-dominant wrist. The appropriate wear location
is dependent on specific research objectives and will be outlined in the study protocol.
Note: The device must be worn at the wrist location to obtain accurate readings from the wear time sensor.
Note: The device must be worn at the wrist location to obtain accurate sleep score information.
10
Wrist worn devices
Insert the ActiGraph Link into the wrist strap by positioning the plastic notch on
the bottom edge of the device into the matching groove in the bottom edge
of the watchband. Ensure that the ActiGraph logo on the device and the 'A' on
the watchband are facing in the same direction. Gently push down on the upper
portion of the device until it snaps into place.
The subject should be instructed to wear the device strapped securely to the non-
dominant wrist with the logo facing up when viewed like a wrist watch.
To remove the ActiGraph Link from the watchband, firmly grasp and pull up on
the device with one hand while gently lifting the plastic tab on the top edge of
the watchband with the other hand.
Waist worn devices
Belt Clip
Insert the ActiGraph Link into the belt clip by positioning the plastic notch on
the bottom edge of the device into the matching groove on the bottom edge
of the belt clip. Ensure that the ActiGraph logo faces up when the clip opening
faces down. Clip the device to the elastic waist belt or the subjects' own belt or
waistband. The belt should be fastened securely against the subject so the device
is snug against the body.
To remove the ActiGraph Link from the belt clip, firmly grasp and pull up on the
device with one hand while gently lifting the plastic tab on the top edge of the
belt clip with the other hand.
(Continued)
actigraphcorp.com
Hide quick links:
Advertisement
