Getting Started - ActiGraph GT9X Link + ActiLife Quick Start Manual

Getting Started

1
Install ActiLife software
You must be running ActiLife version 6.11.5 or higher to operate
the ActiGraph Link device.
1
2
View ActiLife System Requirements
Note: The ActiLife full version and ActiLife Lite can both be used to initialize
and download data from the ActiGraph Link. However, the ActiLife full
version is required to view and/or process the collected data.
2
Charge the battery
ActiGraph Link devices contain a rechargeable battery that should
be fully charged before initialization and deployment to subjects.
ActiLife will not initialize a device if the battery has dropped below
a certain level. It takes approximately three hours to charge a fully
depleted battery.
1
2
3
4
Go to
http://www.actigraphcorp.com/product-category/software
and click the 'Download' button. Follow the prompts to install
the ActiLife software on your PC.
When prompted, enter the ActiLife license key that was
provided at the time of purchase to complete the installation.
Connect the Link dock to the computer or a wall outlet using
the mini USB cable.
Plug the ActiGraph Link into the dock with the ActiGraph logo
facing up. Once connected, the red LED light on the right
side of the dock will turn yellow, the device screen will display
the serial number, and the battery icon will blink to indicate
charging.
Once the device is fully charged, the yellow light will turn
green and the battery icon on the device will show as full and
stay on steady.
USB Connected
Indicator Light
actigraphcorp.com
Device Charging
Indicator Light