Glide Centro Owner's Manual page 31

Table of Contents

Advertisement

The foregoing in lieu of all other warranties expressed, implied or statutory, Lendal Pty Ltd's sole
liability shall be to repair or replace parts of components as specified on page 29.
1.
Lendal Pty Ltd (trading as Glide Rehabilitation Products) does not warrant
either expressly or impliedly the suitability of the Glide Centro electric
wheelchair for the purchaser or any intended user. Purchasers and intended
users are advised that advice from an appropriate registered medical
practitioner should be obtained prior to using an electric wheelchair.
2.
Except insofar as is prohibited by statute, Lendal Pty Ltd shall not be
responsible for damage, injury or loss of any kind to any property or
person howsoever caused arising from or in connection with the Glide
Centro. All conditions and warranties that (but for this provision) would be
implied in favour of, and all rights and remedies that (but for this
provision) would be conferred upon the purchaser or other persons against
Lendal Pty Ltd arising under or as a result of the Trade Practices Act 1974,
any other legislation or the general law are excluded and limited to the
maximum extent possible and in cases where Lendal Pty Ltd's liability
cannot be completely excluded but may be limited, the liability of Lendal
Pty Ltd is limited to one of the following (at the option of Lendal Pty Ltd)
a)
b)
c)
d)
Glide Rehabilitation Products are manufactured in Australia by Lendal Pty. Ltd.
IMPORTANT
The replacement of the Glide Centro or the supply of an
equivalent wheelchair
The repair of the Glide Centro
The payment of the cost of replacing the Glide Centro or of
acquiring an equivalent wheelchair
The payment of the cost of having the Glide Centro repaired
REHABILITATION PRODUCTS
(ACN 009 003 694)
25 Ledgar Road Balcatta, Western Australia 6021
Phone: +61 8 93453400 Fax: +61 8 93451384
Email:
Web:
Australia
sales2@glide.com.au
www.glide.com.au
31

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents