GMC Yukon Denalid Owner's Manual page 278

Noise Compensated Volume (NCV): If your
vehicle is equipped with a Bose
includes Bose AudioPilot
technology instead of SCV. When turned ON,
®
AudioPilot continuously adjusts the audio system
equalization, to compensate for background
noise, so that your music always sounds the same
at the set volume level.
This feature is most effective at lower radio
volume settings where background noise can
affect how well you hear the music being played
through your vehicle's audio system. At higher
volume settings, where the music is much louder
than the background noise, there may be little
or no adjustments by AudioPilot
To activate NCV:
1. Set the radio volume to the desired level.
2. Press the MENU button to display the radio
setup menu.
3. Press the pushbutton under the AUTO
VOLUM label on the radio display.
4. Press the pushbutton under the ON label.
The display will time out after approximately
10 seconds.
278
®
Audio System, it
®
noise compensation
®
.
Finding a Station
BAND: Press this button to switch between AM,
FM, or XM™ (if equipped). The display will
show the selection.
f
(Tune): Turn this knob to select radio stations.
© ¨
SEEK : Press the right or left SEEK
arrow to go to the next or to the previous station
and stay there.
To scan stations, press and hold either SEEK
arrow for a few seconds until you hear a beep. The
radio will go to a station, play for a few seconds,
then go on to the next station. Press either
SEEK arrow again to stop scanning.
The radio will only seek and scan stations with a
strong signal that are in the selected band.