Turn And Lane-Change Signals - GMC Yukon Denalid Owner's Manual

(Windshield Wipers): See Windshield
N
Wipers on page 196.
( Windshield Washer): See Windshield
L
Washer on page 198.
5
(Rear Wiper Delay): See Rear Window
Wiper/Washer on page 199.
Z
(Rear Wiper): See Rear Window
Wiper/Washer on page 199.
(Rear Wiper Wash): See Rear Window
=
Wiper/Washer on page 199.

Turn and Lane-Change Signals

The turn signal has two upward (for right) and
two downward (for left) positions. These positions
allow you to signal a turn or a lane change.
To signal a turn, move the lever all the way up or
down. When the turn is finished, the lever will
return automatically.
194
To signal a lane change, raise or lower the lever for
less than one second until the arrow starts to flash.
This will cause the turn signals to automatically
flash three times. It will flash six times if tow-haul
mode is active. Holding the turn signal lever for
more than one second will cause the turn signals
to flash until you release the lever. The lever will
return by itself when it is released.
As you signal a turn or a lane change, if the
arrows flash more quickly than normal, a signal
bulb may be burned out and other drivers will not
see your turn signal.
If a bulb is burned out, replace it to help avoid an
accident. If the arrows do not go on at all when
you signal a turn, check for burned-out bulbs and a
blown fuse. See Fuses and Circuit Breakers on
page 538.
An arrow on the
instrument panel cluster
will flash in the
direction of the turn or
lane change.