Icom IC-F15 User Manual page 4

VHF AND UHF TRANSCEIVERS
SPECIFICATIONS
• Frequency range
IC-F15/IC-F15S
IC-F25/IC-F25S
• Number of channels
• Channel spacing
• PLL channel step
• Power supply requirement : 7.2V DC
• Current drain
(at 7.2V DC; approx.)
Transmit VHF
(5W)
UHF
(4W)
Receive stand-by
rated output
• Antenna impedance
• Usable temperature range : –25˚C to +55˚C
• Dimensions
(with BP-231)
(projections are not included)
• Weight
(approx. with BP-231)
• Output power
• Max. frequency deviation : ±5kHz
• Frequency error
• Spurious emissions
• Adjacent channel power :
VHF
UHF
• Residual modulation
(With CCITT filter)
• Audio harmonic distortion : 3%
• Modulation limiting
• External microphone connector :
Measurements made in accordance with EN 300-086.
All stated specifications are subject to change without notice or obligation.
1-1-32, Kamiminami, Hirano-ku, Osaka 547-0003, Japan Phone: +81 (06) 6793 5302
JP98/14190QA TW03/00288EM
Icom Inc. (Japan), is an ISO 9001 and ISO
14001 certification acquired company.
GENERAL
:
136–174MHz
400–470MHz
: 16
(IC-F15, IC-F25)
4
(Max., IC-F15S, IC-F25S)
: 12.5kHz/20kHz/25kHz
: 2.5kHz, 3.125kHz
(VHF)
5kHz, 6.25kHz
(UHF)
:
1.5A
1.6A
70mA
300mA
: 50Ω
×120 ×38
: 53 mm
(W) (H) (D)
: 260g
TRANSMITTER
: 5W , 4W
(VHF) (UHF)
(Wide)
±4kHz
(Middle)
±2.5kHz
(Narrow)
: ±2.5ppm
: 0.25µW
(below 1GHz)
1.0µW
(above 1GHz)
80/80/70dB
typ. (Wide/middle/narrow)
75/73/68dB
typ. (Wide/middle/narrow)
: 55dB
typ. (Wide)
53dB
typ. (Middle)
50dB
typ. (Narrow)
typ. (AF 1kHz, 40% deviation)
: 60–100% of max. deviation
3-conductor 2.5 mm /2.2kΩ
(d)
• Sensitivity
• Squelch sensitivity
• Adjacent channel selectivity :
VHF
UHF
• Spurious response
• Intermodulation
• Hum and noise ratio
(with CCITT FILTER)
• Audio output power
• External speaker connector: 2-conductor 3.5
Applicable U.S. Military Specifications
Icom makes rugged products that have been tested to and passed the
following MIL-STD requirements and strict environmental standards.
MIL 810C
Standard
Method Proc.
Low Pressure 500.1
I
High Temp. 501.1 I
Low Temp. 502.1 I
Temp. Shock 503.1
I
Solar Radiation 505.1 I
Rain Blowing/Drip 506.1 I, II
Humidity 507.1
I, II
Salt Fog 509.1 I
Dust Blowing 510.1 I
Vibration 514.2
VIII, X
Shock 516.2 I, II, V
SUPPLIED ACCESSORIES
(May differ according to version)
• Belt clip, MB-94 • Unit cover
Fax: +81 (06) 6793 0013 URL: http://www.icom.co.jp/world/index.html
Maximon Solutions
22 Soho Mills
Wooburn Green
Buckinghamshire
HP10 0PF
RECEIVER
: –4dBµV
typ. (emf, at 20dB SINAD)
: –4dBµV
typ. (emf, at threshold)
75dB
typ. (Wide, middle)
65dB
typ. (Narrow)
75/73/65dB
typ. (Wide, middle, narrow)
: 70dB
: 67dB
typ.
: 55dB
typ. (Wide)
53dB
typ. (Middle)
50dB
typ. (Narrow)
: 500mW
typ.
(at 5% distortion with an 8Ω load)
mm/8Ω
(d)
MIL 810D MIL 810E
Method Proc. Method Proc. Method
500.2 500.3 500.4
I, II I, II
501.2 I, II 501.3 I, II 501.4
502.2 I, II 502.3 I, II 502.4-3
503.2 503.3 503.4
I I
505.2 I 505.3 I 505.4
506.2 I, II 506.3 I, II 506.4
507.2 507.3 507.4
II, III II, III
509.2 I 509.3 I 509.4
510.2 I 510.3 I 510.4
514.3 514.4 514.5
I I
516.3 I, IV 516.4 I, IV 516.5
• VHF Antenna
• UHF Antenna
• Battery pack, BP-231
Count on us!
Your local distributor/dealer:
T: 0845 873 6250
F: 0845 873 6251
E: sales@maximonsolutions.com
04ES012C © 2004–2005 Icom Inc.
MIL 810F
Proc.
I, II
I, II
I, II
I
I
I, III
–
–
I
I
I, IV
Printed in Japan