Advertisement
Quick Links
Life Fitness Model 9500L Cross-Trainer
How To...Remove and Replace the 4", and 14" Linkage Assemblies
Tools Required: Torx Key or Standard Screwdriver, Socket Set, Wrench Set, Hex Key Set Kit # GK53-00002-0021
PLEASE READ THROUGH THESE INSTRUCTIONS BEFORE ATTEMPTING TO INSTALL THIS KIT.
FAILURE TO FOLLOW THE STEPS IN PROPER SEQUENCE COULD CAUSE DAMAGE TO THE EQUIPMENT.
1
Washer
0017-00104-0402
4
Metal Washer
0017-00104-0369
7
Bolt w/Locktite
0017-00101-1610
10
Bolt
0017-00101-1606
WARNING: FAILURE TO OBSERVE SAFETY PROCEDURES WHEN SERVICING THIS UNIT
1
5
8
11
IMPORTANT!
Qty: 4
2
Brass Washer
0017-00006-0226
Qty: 4
5
Shouldered Sleeve
0K53-01346-0017
Qty: 2
8
External Lock Washer
0017-00104-0302
Qty: 2
11
Bolt
0017-00101-1608
COULD RESULT IN INJURY FROM ELECTRICAL SHOCK
2
6
9
10
Qty: 4
Qty: 4
Qty: 4
Qty: 2
3
7
3
Delrin Spacer
OK53-01384-0000
6
3/4" Sleeve
OK53-01342-0000
9
Jam Nut
0017-00103-0273
4
Qty: 4
Qty: 2
Qty: 4
Advertisement
Related Manuals for Life Fitness 9500L
Summary of Contents for Life Fitness 9500L
- Page 1 Life Fitness Model 9500L Cross-Trainer How To...Remove and Replace the 4”, and 14” Linkage Assemblies Tools Required: Torx Key or Standard Screwdriver, Socket Set, Wrench Set, Hex Key Set Kit # GK53-00002-0021 PLEASE READ THROUGH THESE INSTRUCTIONS BEFORE ATTEMPTING TO INSTALL THIS KIT.
- Page 2 Life Fitness Model 9500L Cross-Trainer How To...Remove and Replace Hardware in the 4”, and 14” Linkage Assemblies (Continued) Step 1 Turn power OFF at the On/Off switch and unplug the line cord from the electrical outlet. Step 2 Locate the two PUSH SNAP RIVETS (A) securing the top of the HOOD SHROUD PANEL (B) to the top of the REAR SHROUD PANEL (C).
- Page 3 Life Fitness Model 9500L Cross-Trainer How To...Remove and Replace the 4”, and 14” Linkage Assemblies (Continued) Step 9 Using a 1/2” socket, remove the BOLT (W) (discard old bolt), EXTERNAL TOOTH WASHER (X), SMALL EXTENSION ARM (Y), and PLASTIC WASHER (Z), from the CRANK ARM ASSEMBLY.
- Page 4 Life Fitness Model 9500L Cross-Trainer How To...Remove and Replace the 4”, and 14” Linkage Assemblies (Continued) Step 15 Attach the forward end of the 14” LINK BAR to the SMALL EXTENSION BAR (Y). Position the thin METAL WASHER (#1) over the shouldered edge of the SHOULDERED SLEEVE (#5), and slide the 14” LINK BAR (I) over the non- shouldered edge of the SHOULDERED SLEEVE.