Pride Victory Viper-3 Owner's Manual page 31

V I I . C O M F O R T A D J U S T M E N T S
ARMREST ANGLE ADJUSTMENT
The armrest angle of your scooter can be adjusted upward or downward by turning the adjustment dial
located on the underside of the armrest
NOTE: The armrests also pivot upward to make getting onto and off of your scooter easier.
LUMBAR SUPPORT ADJUSTMENT DIAL
The lumbar support is in the lower part of the seatback. To adjust the lumbar support, turn the adjustment
dial on the side of the scooter seat anticlockwise until you reach a comfortable position.
POSITIONING BELT
Your scooter seat may be equipped with an auto-type positioning belt that can be adjusted for operator
comfort. See figure 20. The positioning belt is designed to help support the operator so that he or she does
not slide down or forward in the seat. The positioning belt is not designed for use as a restraining device.
To install the positioning belt (if required):
1. Remove the seat from your scooter.
2. Place the seat upside down so that you can see the bottom of the seat base. See figure 19.
3. Using a 5-mm hex key, remove the two bolts on the outermost part of the rear seat mounting strap.
4. Insert the bolt through the appropriate end of the positioning belt and then through the seat mounting
strap for each side of the scooter seat.
5. Tighten the bolts.
To adjust the positioning belt for operator comfort:
1. Insert the metal tab on the right side of the belt into the plastic housing on the opposite strap until you
hear a “click.”
2. Pull the strap on the right side of the belt until it is secure, but not so tight as to cause discomfort.
REMOVE BOLTS
POSITIONING
BELT
SEAT RECLINE
LEVER
SEAT SLIDING
LEVER
Figure 19. Positioning Belt Installation
Victory Viper-3/Rev A/May 2003
SEAT MOUNTING STRAP
REMOVE BOLTS
SEAT LOCK
LEVER
www.pridemobility.com
Figure 20. Positioning Belt
31