KitchenAid 810-0021 Installation Instructions And Use & Care Manual page 12

4. Loosen the screws in inside face of front and rear cross
bar on the bottom, then slide the bottom panel into the
screws and tighten them as shown.
5. Screw the caster without brake into the front leg and
screw the caster with brake in rear as shown.
6. Take the cap off, remove the screws and washer from
leg axle, then assemble the wheels onto axle and add
washers and nuts and tighten. Add the cap as shown.
12
7. Loosen eight screws on the top cross bar and rear panel. Then
place the two panels and slide into the hole as shown, do not tighten
the screws at this step.
8. Place the bracket on the middle ,then slide into the holes and
tighten the screws as shown.
9. Place the brackets on the left and right side ,then slide into
the holes and tighten the screws as shown.