Dodge Charger SRT 2014 Owner's Manual page 418

416 STARTING AND OPERATING
3. Make sure the vehicle is not moving.
4. Make sure the steering wheel is pointing straight.
5. Hold the brake and make sure the vehicle is in
"Drive".
6. While holding the brake, rapidly apply the accelerator
pedal to wide open throttle. The engine speed will
hold at approximately 1825 RPM for the quickest
launch.
• Messages will appear in the cluster EVIC display to
inform the driver if one or more of the above
conditions (3 through 6) have not been met.
7. When conditions 3 through 6 have been met, the
cluster EVIC display will read "Launch Ready Release
Brake".
Release the brake and continue to hold wide open
throttle to launch.
8. Keep the vehicle pointed straight.
Launch control will be active until the vehicle reaches
62 mph (100 kph), at which point the ESC system
continues in ESC Full ON mode. Activating Launch
Control again from this state will require pressing the
"ESC OFF" button twice. Repeat steps 3 through 8.
Launch control will abort before launch completion and
display "Launch Aborted" in the cluster under any the
following conditions:
• The accelerator pedal is released during launch. ESC
system continues in ESC Full ON.
• The ESC system detects that the vehicle is no longer
moving in a straight line. ESC system continues in ESC
Full ON.
• The "ESC OFF" button is pressed to change the system
to another mode. One press puts the ESC system into
ESC Full-On.