Dodge Charger SRT 2014 Owner's Manual page 140

138 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Toggling Between Calls
If two calls are in progress (one active and one on hold),
press the button until you hear a single beep, indicat-
ing that the active and hold status of the two calls have
switched. Only one call can be placed on hold at a time.
Also you can press the "Swap" soft-key on the Phone
main screen.
Join Calls
When two calls are in progress (one active and one on
hold), push the "Join Calls" button on the Phone main
screen to combine all calls into a Conference Call.
Call Termination
To end a call in progress, momentarily press the "End"
soft-key or the button. Only the active call(s) will be
terminated and if there is a call on hold, it will become
the new active call. If the active call is terminated by the
far end, a call on hold may not become active automati-
cally. This is cell phone-dependent.
Redial
1. Touch the "Redial" soft-key, or press the
and after the "Listening" prompt and the following
beep, say "Redial."
2. The Uconnect® Phone will call the last number that
was dialed from your mobile phone.
Call Continuation
Call continuation is the progression of a phone call on the
Uconnect® Phone after the vehicle ignition key has been
switched to OFF.
• After the ignition key is switched to OFF, a call can
continue on the Uconnect® Phone either until the call
ends, or until the vehicle battery condition dictates
cessation of the call on the Uconnect® Phone and
transfer of the call to the mobile phone.
button