Specifications; Standard Accessories; Optional Accessories (Sold Separately); Prior To Operation - Hitachi C 6SS Handling Instructions Manual

7. Never use the circular saw with its lower guard fi xed in
the open position.
8. Ensure that the retraction mechanism of the guard
system operates correctly.
9. Never operate the circular saw with the saw blade
turned upward or to the side.
10. Ensure that the material is free of foreign matters such
as nails.

SPECIFICATIONS

Model
Voltage (by areas)*
Cutting Depth
Power Input
No-Load Speed
Weight (without cord)
* Be sure to check the nameplate on product as it is subject to change by areas.

STANDARD ACCESSORIES

(1) Saw Blade (mounted on tool) .......................................1
(
Dia. 165 mm ...............C6SS
Dia. 190 mm ...............C7SS
(2) Hex. Bar wrench ...........................................................1
Standard accessories are subject to change without
notice.

OPTIONAL ACCESSORIES (sold separately)

(1) Dust Collector Set (D)
Connect the suction hose to collect saw dust with the
vacuum cleaner (see Fig. 1).
Dust collector
(2) Washer (A)
.................. for 20 mm (Hole dia. of saw blade)
.................. for 30 mm (Hole dia. of saw blade)
NOTE
If the saw blade supplied with your circular saw has
a hole diameter of 15.9 mm, only saw blades with the
same size hole diameter can be fi tted to your circular
saw.
(3) Guide (with wing-bolt)
Optional accessories are subject to change without notice.
4
90°
45°
3.2 kg
(Aluminum Base)
)
Fig. 1
11. For model C6SS, the saw blades range should be from
165 mm to 160 mm.
For model C7SS, the saw blades range should be from
190 mm to 185 mm.
12. Disconnect the plug from the receptacle before carrying
out any adjustment, servicing or maintenance.
C6SS
(110 V, 120 V, 220 V, 230 V 240 V)
57 mm
38 mm
1050 W
5500/min
3.1 kg
(Steel Base)
APPLICATION
Cutting various types of wood.

PRIOR TO OPERATION

1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specifi ed on the product
nameplate.
2. Power switch
Ensure that the power switch is in the OFF position. If
the plug is connected to a receptacle while the power
switch is in the ON position, the power tool will start
operating immediately, which could cause a serious
accident.
3. Extension cord
When the work area is removed from the power source,
use an extension cord of suffi cient thickness and rated
capacity. The extension cord should be kept as short as
practicable.
4. Prepare a wooden workbench (Fig. 2)
Since the saw blade will extend beyond the lower surface
of the lumber, place the lumber on a workbench when
cutting. If a square block is utilized as a workbench,
select level ground to ensure it is properly stabilized. An
unstable workbench will result in hazardous operation.
Lumber
Workbench
C7SS
68 mm
46 mm
3.4 kg
(Aluminum Base) (Steel Base)
Base
Saw blade
Fig. 2
3.3 kg