Dh (Slt) - Lapierre CARBON Owner's Manual

SET-UP
For the FROGGY:
The SAG should be adjusted to between 20 and 30% according to your riding style and the type of terrain.
For the Froggy bikes that have a pressure set up system in the additionnal cylinder, please refer to the
user's manual and do not exceed the pressure recommended by the manufacturer (from 8,5 to 13 bars
for Fox DHX shock absorbers). The higher the pressure, the better the control of the compression. A high
pressure is necessary if you want to do big jumps.
Please refer to the user's manual provided by the shock manufacturer to know more about the maintenance
of your shock absorber and precise set ups.
Tips:
• Having someone check the position of the indicator for you will help you get the best setting, since there
may be an angle mistake when you are seated on the saddle.
• To check your setting, you can slightly bounce while you are on the saddle and check that the indicator
returns to the equilibrium point. Also, in order to have the most precise setting possible, do not hesitate to
adjust your suspension while fully equipped (with helmet, hydration bag, etc.).
2011 and 2012
6.1 - REAR SHOCK ABSORBER SETTINGS
SET-UP
To correctly adjust the FOX and ROCK SHOX shocks, please consult the user guides provided by the
constructor.
6.2 - CHANGING THE HEAD ANGLE
Steps to follow for DH 2011 and 2012
1 - Remove the eccentric LAPIERRE pressed cups.
fig 1 2 - Turn the two cups in the frame 1/2 a turn to change the head angle, then insert the cups.
3 - The mark on the cups will show the current angle. HA: 63.5°+0.5° = 64° or 63.5°-0.5° = 63°
Warning : The two cups must be mounted with the two marks showing the same head angle!
fig 2
Steps to follow for DH models from 2013
1 - Remove reducers supplied with your LAPIERRE DH. (Angle 0 °)
2 - Select the pair of cups of your choice (angle 0.5 ° - 1 ° or 1.5 ° depending on model). Sold separately.
3 - Orient cups as in fig 2 to increase head tube angle or conversely to reduce it.
4 - Press the cups in the Head tube.
Warning: Both cups should be mounted in pairs, the two marks indicating the same angle !
2013

6 - DH (SLT)

III - SPECIFIC MODELS
SPECIFIC MODELS - 15