NavRoad RECO2 User Manual page 129

Brightness
Press Brightness button to go to screen backlight settings. This screen has two settings bars enabled
depending on the power mode of the device. The top bar allows you to adjust brightness when
device is connected to a power supply. Bottom control bar is disabled. If the device is in battery
mode, the brightness setting is possible by adjusting the bottom bar of brightness. In this situation,
the top bar is disabled.
Sound
Press Sound button to adjust volume and switch on/off screen taps sound. Additionally, it's possible
to adjust the sound by the equalizer.
Your navigation software has additional independent brightness and volume controls.
CAUTION! Low brightness and volume can increase battery life.
Power
Press Power button to get battery status and set the time to auto stand-by mode. You can also
switch off the screen which appears when you disconnect the charger.
Time
Press Time button to set time, date and time zone of the internal clock.