Extron electronics DTP DVI 330 User Manual page 18

3. Locate, lift off, and discard jumpers JMP2 and JMP3 from both units (see figure 10).
JMP2
JMP3
Transmitter
Figure 10. Jumper Locations
4.
Reinstall the covers on both units, securing them in place with the screws removed in
step 2.
5. Reinstall both units in their racks or other installation option (see
Transmitter and Receiver
6.
either end of the cable.
7.
Obtain a second 12 V power supply (one supply is provided with the transmitter and
normally powers both units), and locally power both units (see
on page 8).
Receiver
on page 10).
, disconnect the cable shield from the connector at
JMP2
JMP3
Mounting the
Power supply wiring
12