Viscount CM-100 User Manual page 44

VISCOUNT
CM-100
In the usual way, when you press ENTER the new voice selected will replace the one present in the
selected stop. To confirm this has taken place, the display will show the following video page
WARNING!
reminding you that you have to physically change the label on the stop, because its contents have been
changed.
Then press EXIT to scroll back to the previous pages and make a new selection or return to the main
operating page.
6.2 Changing labels
6.2 Changing labels
Once you have loaded one or more voices it is a good idea to change the labels of the stops, to ensure
that the name of the stop is the same as that of the voice loaded in the memory.
It is very easy to change the labels because they are just pressed into the stop.
Remove the label with your fingers or using a small screwdriver (as shown below) and fit the correct one.
The Factory Settings procedure allows you to restore the factory settings of all the instrument's internal
parameters (voices inclueded), deleting all the changes made by the user.
To perform the Factory Settings procedure, switch the instrument on while keeping the Voice memory
1, 2 and 3 keys pressed, until the display shows the following video page
Release the keys. After a few moments, the message confirming that the factory settings have been
loaded will be displayed.
The instrument will automatically be rebooted.
Tab 1 now is CtPrinc32
- Please change the label -
7. FACTORY SETTINGS
7. FACTORY SETTINGS
RESTORING FACTORY SETTINGS
PLEASE WAIT
FACTORY SETTINGS RESTORED
Page 19
Pipe Organ Module