Viscount CM-100 User Manual page 30

VISCOUNT
CM-100
1.2 Description of the rear p
1.2 Description of the rear p
POWER ON: On/off switch
o
AC INPUT connector: connect the power supply lead supplied with the instrument to this connector.
The CM100 is able to operate on power supply voltages from 90 to 250 Volts AC.
o
OUTPUTS connectors (from 1 to 6). Line outputs from which the audio signal can be collected to be
sent to amplified sound diffusion systems, or any amplification system of any kind. For the best instru
ment audio performance and for high-fidelity reproduction of the acoustic panorama generated by the
windchests, it is absolutely essential to connect the outputs consecutively, always starting from output
number 1. For the same reason, it is very important to take care when positioning the Loudspeaker,
as described in point 1.4 of this manual.
o
PHONES connector: jack 5" 1/4 socket to which a headphone set (not supplied) can be connected. It
is important to use good quality headphones, with impedance of at least 16 Ohm
o
EXP. PED connector: use this jack socket to connect an expression pedal (not supplied) to the CM-
100. To assure good results, use linear response expression pedals having impedance of 22 Kohm,
and fitted with stereo jack connector. For calibration operations, use the "EXP.PEDAL" menu (system
environment); see advanced manual for the relative instructions.
o
MIDI (IN, OUT and THRU) connectors: five-pin DIN connectors for connection of instruments with MIDI
interface. The IN connector allows reception of MIDI data generated by remote MIDI sources, the OUT
connector transmits the MIDI messages generated by the CM-100, and the THRU connector transmits
exactly the MIDI data received by the IN connector.
o
RS-232 connector. Serial connector for connecting the CM-100 to a computer (see advanced manual)
anel
anel
Page 5
Pipe Organ Module