King-Dome KD2000 Owner's Manual page 25

King dome kd2000; kd3000; 9704-lp; 9754-lp automatic satellite tv antenna
Table of Contents

Advertisement

DISH AND BELL TV CHECK SWITCH TEST
IMPORTANT! YOU MUST HAVE COMPLETED THE ANTENNA CONFIGURATION (PAGE 13), BEFORE
CONTINUING BELOW).
NOTE: For automatic satellite switching, KING recommends using a DISH model 311 receiver for DISH SD, and
a DISH model ViP211z, ViP211k or a ViP211 HDTV receiver for DISH SD and HD and DISH SD and HD
Alternate. KING does not recommend the use of dual tuner receivers or receivers with built-in recorders when
using the automatic satellite switching feature.
If you do not have a clear view of all satellites, the switch will not load correctly.
The SW21 and SW64 switches are a receiver software confi guration that is loaded into the receiver after
successfully running a check switch test with the dish locked on and confi gured for the appropriate service.
This one time procedure will not need to be repeated after successful installation, unless:
a) check switch test is run again while connected to a home dish system.
b) check switch test is run when a receiver is not connected.
c) you travel outside the coverage area of either DISH SD and HD or DISH SD and HD Alternate and switch
to the other.
d) you are parked in an area where the selected satellites are blocked, but are able to select alternate
satellites and get signal.
1. Turn on the TV and satellite receiver.
2. On the KING Dome controller, press and hold the
ON button for 3 FULL SECONDS.
The antenna will locate all of the appropriate satellites
before completing the search process.
After the satellites have been located and the acquisition process is complete,
the status light will be steady green.
If you confi gured the antenna for DISH SD and HD and the antenna cannot acquire the
110, 119, and 129 satellites, you may need to confi gure the antenna for DISH SD and HD
Alternate.
3. On the receiver remote, press MENU, 6, 1, 1.
4. Highlight "Check Switch" and press SELECT.
NOTE: Some receivers may prompt you to select
"Check Switch" a second time to initiate the test.
(Continued on next page)
Screen graphics may vary.
Page 23

Hide quick links:

Advertisement

Table of Contents
loading

Related Products for King-Dome KD2000

This manual is also suitable for:

Kd30009704-lp9754-lp

Table of Contents