Directv Sd (Factory Pre-Set); Directv Sd With Locals - King-Dome KD2000 Owner's Manual

The KING Dome is factory pre-set for the DIRECTV 101 satellite. Unless the antenna has been confi gured for
another option since leaving the factory, PERFORM STEP 5 ONLY.
1. On the KING Dome controller, press and release the ON button.
Wait for status light to fl ash orange, then WAIT 4 MORE SECONDS.
2. Press and release the ON button 16 times.
The status light starts rapidly fl ashing green and red.
3. Press and hold the
orange for 1 second, and then start fl ashing green or red.
4. Press OFF.
RECEIVER CONFIGURATION
5. If you have a newer receiver or current software, choose the following dish confi guration
settings (do this through the receiver's satellite set-up menu screens):
Switch Type: 02:Multiswitch
If you have an older receiver, choose round dish-1 satellite.
Confi guration is complete. Go to page 26.
DIRECTV SD with Locals (Satellites 101, 119)
1. On the KING Dome controller, press and release the ON button.
Wait for status light to fl ash orange, then WAIT 4 MORE SECONDS.
2. Press and release the ON button 8 times.
The status light starts rapidly fl ashing green and red.
3. Press and hold the
orange for 1 second, and then start fl ashing green or red.
4. Press OFF.
RECEIVER CONFIGURATION
5. If you have a newer receiver or current software, choose the following dish confi guration
settings (do this through the receiver's satellite set-up menu screens):
Switch Type: 02:Multiswitch
If you have an older receiver, choose oval dish-2 satellites.
Confi guration is complete. Go to page 26.
DIRECTV ANTENNA CONFIGURATION
DIRECTV SD (Satellite 101)
button for 4 seconds. The status light will turn
Dish Type: 01: 18" Round
button for 4 seconds. The status light will turn
Dish Type: 02: 3-LNB (18 x 20")
Page 15