King-Dome KD2000 Owner's Manual page 12

INTERNAL WIRING
NOTE: Components and wiring supplied with the KING Dome are shown in black. Existing components and wiring or
those sold separately are shown in gray.
15. Choose your desired wiring confi guration.
DIRECTV / Bell TV
(single satellite) . . . . . . . . . . . . . . . . . . . . . . . . . Fig. 11, Page 11
DIRECTV / DISH / Bell TV
(2 or more satellites with auto switching) . . . . . Fig. 12, Page 12
16. Inside the vehicle, make the connections as shown in the wiring diagrams, keeping in mind the
following important points:
a) The connection between the antenna unit and the main satellite receiver must be a direct
connection with no other devices in between.
b) Power connection must be a non-shared circuit. Excessive current draw on the circuit will
cause the unit to operate improperly. Power and ground connections must be made after
all wiring is connected to the antenna unit.
c) If fusing the circuit, the fuse must be rated at 7.5 amps.
d) HDTV receivers require HDMI or component video/audio cable connection to TV (sold
separately).
17. When installation is complete, go to Section 4, ANTENNA CONFIGURATION on page 13.
Page 10