Before cleaning the washer interior, unplug the electrical power cord to avoid electrical shock hazards.
When disposing of the appliance, cut off the power cable, destroy the plug, and disable the door lock to prevent
young children from being trapped inside.
¡ÆThe water inlet filter
" error message will blink on the control panel when water does not enter the dispenser.
• If your water is very hard or contains traces of lime deposit, the water inlet filter may become clogged.
We recommend cleaning it every few months.
¡ÆThe drain pump filter
The drain filter collects threads and small objects left in the laundry.
Check regularly that the filter is clean to ensure smooth running of your machine.
First drain using the drain hose and then open the pump filter to remove objects.
Allow the water to cool down before cleaning the drain pump filter.
1. Open the lower cover cap ( )
Turn the drain plug ( ) to pull
out the hose.
1. Turn off the
3. Clean the
Be careful when draining if the water is hot.
2. Unplug the drain plug ( ),
allowing the water to flow out.
At this time use a vessel to
prevent water from flowing
onto the floor. When water does
not flow any more, turn the
pump filter ( ) open to the left.
3. Remove out any foreign objects
from the pump filter ( ). After
cleaning, turn the pump filter ( )
clockwise and insert the drain
plug ( ) to the original place.
Close the lower cover cap( ).
4. Tighten up