Operating Instructions - San Remo Stoves 4kW Installation And Operating Instructions Manual

Care should be taken to level the stove using the adjusting screws in the feet.
The appliance shall be installed on a floor with adequate load-bearing capacity. If the existing
construction does not meet this prerequisite, suitable measures (e.g. load disturbing plate) should
be taken to achieve it.
Safety Distances from Combustible Surfaces:
San Remo 4
San Remo 6
San Remo 8
San Remo 12
San Remo 16
Commissioning and Handover
Upon completion of the installation, allow a suitable period of time for any fire cement and
mortar to dry out. A small fire may then be lit and checked to ensure the smoke and fumes are
taken from the stove up the chimney and emitted safely to atmosphere. Do not run the stove at
full output for at least 3 – 4 days.
On completion of the installation and commissioning, ensure that the operating instructions and
operating tools for the stove are left with the customer. Ensure to advise the customer on the
correct use of the appliance with the fuels likely to be used on the stove and warn them to use
only the recommended fuels for the stove.
Advise the user on what to do should smoke or fumes be emitted from the stove. The user
should use a suitable fireguard in the presence of children, aged and/or infirm persons.
Appliance weight:
Flue gas mass flow:
g/s
*Flue Temp: Deg C
*under nominal heat output

Operating Instructions

This appliance is not suitable for use in a shaped flue.
This appliance should not be operated with the doors open.
Aerosol Sprays
Do not use an aerosol spray on or near the stove when it is alight.
Side Rear
500mm 700mm
400mm 400mm
500mm 500mm
700mm 1000mm
600mm 600mm
San San
Remo 4 Remo 6
75kg 100kg
3.5 3.9
247 296
San San
Remo 8 Remo 12
135kg 180kg
5.0 7.4
293 335
San
Remo 16
211kg
9.8
345
HD01 18/12/11