Prem-I-Air PD14DEN Instruction Manual page 5

4. DISPLAY
Shows the set % humidity level while setting and actual room % humidity level
when running.
Also shows the System fault codes:
E1 – humidity sensor error
E2 – temperature sensor
P1 – unit is defrosting
P2 – bucket is full
NOTE: If any fault code occurs, refer to TROUBLE SHOOTING section (N) to
resolve.
POWER on indicator light
This indicator light illuminates when connected to the power, and flashes
continuously when temperature sensor malfunctions. (See trouble shooting).
CONTINUE indicator light
Unit in continuous dehumidification model. The unit is operating
continuously for maximum dehumidification until the bucket is full. The
humidity setting control is disabled in CONT DEHUM model.
FULL indicator light
This indicator light illuminates when the bucket is full. After emptying the
bucket and replacing it in the correct position this light switches off.
Power Failure
If there is a power failure, the unit will automatically re-start, in the setting last used, when the
power is restored.
Wait 3 minutes resuming operation:
There is a 3 minute time delay before the compressor restarts after power failure, water tank
full, defrosting or has reach the set humidity level. This is normal and is designed to protect
the compressor.
- 5 -