Door Removal - LG LSC 26905TT User Manual

Door removal

Electric Shock Hazard
Disconnect electrical supply to refrigerator before installing.
Failure to do so could result in death or serious injury.
If your entrance door is too narrow for the
refrigerator to pass through, remove the
refrigerator door and pass the refrigerator laterally.
Remove the lower cover by lifting upward, and
then pull up the water feed tube while pressing
area shown in the figure to the right.
If a tube end is deformed or abraded, trim the part away.
•
Disconnecting the tube under the door causes about 1.5 litters water to flow out. Please
put a large container at end of tube to prevent water from draining on to the floor.
1) Remove the hinge cover by loosening the
screws. Disconnect all connections except
the ground line.
2) Remove the keeper by rotating it counter
clockwise and then lifting the upper
hinge up .
• When removing the upper hinge, be careful that the door does not fall forward .
3) Remove the freezer compartment door by
lifting it upward. This time, the door should
be lifted enough for the water feed tube to
be completely pulled out.
• After removing the door, take it into the kitchen where you are installing the
refrigerator. Lay it down on a blanket and be careful to avoid damaging the water
feed tube.
1) Loosen the hinge cover screws and remove
the cover. Remove connection wire.
2) Remove keeper by rotating it clockwise
and then remove the upper hinge by lifting
it up .
3) Remove the refrigerator compartment door
by lifting it up.
Water Feed Tube
Hinge
Cover
Upper Hinge
Keeper
Lower hinge
Connection
Wires
Upper Hinge
Lower Hinge
Installation
Lower Cover
Connection
Wires
Earth Line
Upper Hinge
Keeper