Sleeping Power-Save Mode; Shock Alert; Restore Factory Settings; Gprs Setting - TKSTAR LK106 User Manual

5.16Sleeping power-save mode

On normal status, when the unit stoped over 10minutes, it will change to sleeping mode, on this mode, the
power consumption is 4mah/h only.
automatically.
Forced sleeping mode, Setting: Send SMS "sleep+password", the unit will reply "sleep ok", it enter to forced
sleeping power-save mode.
Start device, send SMS "nosleep+password",the unit will reply "nosleep ok", it start GPRS and GPS locating.

5.17 Shock alert

Note: It is e
ffective sending by a
Send SMS command"shock+password", the unit will reply "shock ok
Cancel: Send SMS command "noshock+password", the unit will reply "noshock ok

5.18Restore factory settings

Note: It is e
ffective sending by a
Send SMS command "format", the unit will reply "
"
settings will be canceled.

5.19 GPRS setting

User must send SMS via cell phone to set up IP, port and APN before starting GPRS.
5.19.1 Setting up APN
5.19.1.1 APN standards for Access Point Name and differs from country to country. For more information about
the local APN, inquire with your local GPRS network operator.
5.19.1.2 Text the tracker a SMS "apn+password + Space + your local APN" via a cell phone and if succeeded in
setup, the tracker will return the message "apn ok".
5.19.1.3 e.g. send SMS command "apn123456 cmnet". If succeeded, "apn ok" is returned by the tracker in
SMS.
When it get any command or been moved, it will start GPS locating
uthorized number
uthorized number
The tracher will immediateiy restore the factory settings.All previous
"
.
"
.
10