Making Soup - Andrew James Soup Maker & Blender User Manual

The control panel of the soup maker and blender
1. Standby mode: All lights are on.
2. When using the soup function, the machine will beep once indicating that
the blender will automatically move to the next step of the soup making
process.
3. When you select a function the machine will beep once, indicating that the
blender will automatically move to the next step of the soup making
process.
4. When the procedure is
finished, it will beep 10
times and the middle four
lights will be on, as
illustrated In the diagram.

Making soup

To make soup, proceed with the following steps:
1. Plug your appliance into the mains and turn the mains switch on, you will
hear a beep sound to indicate that it is plugged in.
2. Cut your vegetables in 2cm dices, add water or stock. The food (solid or
liquid) must not exceed the maximum mark of the jug, make sure solid food
is fully covered by liquid. Close the cover.
3. Push the On/Off button, you will hear a beep and all the lights on the
command panel will flash.
4. The heating process starts straight after the cooking is finished. You can stop
this at any time by pressing the button again corresponding to the option
you initially choose.
Caution: High starch food/ ingredients like powder, flour, sugar, milk and cream will
burn if it is put in at the beginning of the cooking process. We recommend adding
them after the completion of cooking, then use the pulse function mix the food/
ingredients for a few seconds.
Notice: You can also make simple compotes such as apple or pear. Add water until
10