Olsberg 14563 Instruction Manual page 34

28. Push out the adjusting knob (K) before install-
ing the outer front panel.
29. Push the insert lugs of the front panel (D) into
the square holes in the lower edge of the floor
plate with an upward clearance of approx.
10cm.
30. Close the front panel onto the heater and
push it over the inner cabinet on the left and
right side. Replace the screws left and right
between the outer and inner front panels.
Caution: Before fixing the screws, make sure
that the insert lugs of the front panel
sit in the square holes and not be-
hind the air-outlet grille.
•
Only for heaters 14/566, 14/567, 14/568:
Replace the fixing bracket (Fig.10):
Mount the fixing bracket into the square hole in the
front panel. Replace the fixing bracket by simulta-
neously pushing the front panel and inner cabinet
rear panel together.
31. If the right hand side panel has been re-
moved, make sure that the fluff filter has not
been squeezed between the panels so that a
replacement at a later date (see „Care and
Maintenance") can be carried out without
problems..
32. Replace the rear panel cover and outer cover-
ing in reverse order to their removal - Steps 1
to 6 (Fig.8).
Caution: When replacing the right hand side
panel screws, make certain that
the „nose" in the upper part of the
side panel sits in the thermostat
mounting plate (L) (Fig.18).
Tip:
To make sure that the „nose" on
the right hand side panel is sitting
in the corresponding slot in the
thermostat mounting plate, pull the
side panel forwards towards the
front panel after about a half-turn
of the upper countersunk screw.
34
10cm
D
29.
Fig.17 Front panel mounting
L
Fig.18 Side panel „Nose" in
thermostat mounting plate
30.
K
„Nose"