Floor-Mounting Brackets (Accessory) - Olsberg 14563 Instruction Manual

Floor-mounting brackets (accessory)

•
When fixing the heater to floor-mounting brackets,
these are first to be fixed flush against the wall, ei-
ther to the floor or the wall with a clearance of „H"
and a tolerance of max. ± 10mm (Fig. 7, table 3)
using suitable materials (mounting holes in the
floor brackets are of 8.5mm diameter). The clea-
rances to be adhered to are found in the chapter
„minimum clearances".
The skirting board must not be higher than 90mm
and not lower than 10mm. If this is not the case,
the skirting board must be cut away at these posi-
tions.
Make certain that the side fixing lugs on the
brackets point towards the outside of the
heater!
•
To prevent the heater tipping, the wall brackets
must be fixed to the mounting wall.
To do this, break off the wall-mounting brackets at
the required position by bending them back and
forward. Only the top part of the bracket is to be
used to prevent tilting.
Fix the shortened wall-mounting brackets to the
wall (using 2 screws per bracket) mid-way above
the floor brackets (Fig.7) using the materials sup-
plied or other, more suitable materials (mounting
holes in the brackets are of 10mm diameter). The
clearances to be adhered to are found in the chap-
ter „minimum clearances".
The wall surface on which the brackets sit should
be even. If this is not the case, suitable underlay
material must be used.
•
Place the heater runners on the floor brackets and
push the heater onto the wall-mounting brackets.
Open the heater as described in steps 1-10 (page
30, Fig. 8+9) and hang it onto the wall brackets.
•
Fix the heater hand tight to the floor bracket using
the hexagonal screws, washers and star washers
provided. Thread the screws through the underside
of the fixing lugs of the floor bracket into the heater
(Fig. 6).
Heater Dim. H
14/563 236
14/564 412
14/565 588
14/566 764
14/567 940
14/568 1116
Table 3
Fig.5 Floor bracket from above
Fig.6 Right hand floor bracket from front
Heater width – see „Technical data"
Fig.7 Tilting prevention bracket /
Heater with floor-mounting brackets
29