Installation Steps; Product Specifications - Philips PPS640-KNX Installation Manual

Network power supply

Hide thumbs

page of 2

/ 2
Bookmarks

PPS640-KNX

Network Power Supply

INSTALLATION MANUAL

Installation Steps

1. Mount the device on a DIN rail inside an approved

enclosure.

2. Connect a single phase feed to the supply terminals.

This device must be earthed.

3. Connect KNX TP1 bus cables. Ensure correct cable

type and lengths. Ensure required cable segregation to

other circuits.

4. Connect Aux Supply cables if required. Ensure correct

polarity and required segregation to other circuits.

5. Re-check all terminations prior to energizing and

energize the supply.

6. Check supply, KNX bus voltage and Aux supply using

a multimeter. Load supply shall be within the load

specification, KNX bus shall be between 21-30Vdc,

Aux supply shall be between 24-30Vdc.

Product Specifications

Supply

120-250V 50/60Hz at 0.5A

Output

640mA @ 29Vdc for direct KNX BUS supply

Protection

Overload protection

Short circuit proof

Supply Terminals

Line, Neutral, Earth Screw Terminal

1 x 1.5mm

max conductor size

Output Terminals

Wago 243 (Red/Grey) for KNX Bus

Wago 243 (Yellow/White) for auxiliary supply

0.6-0.8mm wire diameter single core KNX cable

Warranty Policy

Philips warrant to the original purchaser for a period of twenty four (24) months from the date of shipment ex-factory of the equipment that should the equipment prove defective by

reason of improper workmanship or material, Philips will repair or replace the same without charge provided the equipment has not been improperly installed, operated, repaired, damaged

or abused. The warranty granted herein is limited to repair or replacement only. Philips has the right to substitute any warranty item not on the current price/equipment list. As far as the law

permits, Philips shall not be liable for any loss or damage caused to property or persons arising from any cause whatsoever. This warranty is subject to the return of the equipment to Philips,

or the Philips authorised distributor who supplied the equipment (the 'Supplier'), by prepaid freight within the twenty four (24) months warranty period. Where Philips, or the Supplier, agree

to a site visit during the warranty period and it is found to be an operational problem, and not subject to warranty in that event, then a field service call out charge will apply. Contact Philips

or the Supplier for details.

PPS640-KNX Installation Manual

Rev A March 2012

Specifications subject to change without notice.

Unit 6, 691 Gardeners Road Mascot 2020 Australia.

ABN 33 097 246 921

Connecting KNX Data Cabling

Connect Data Cable in a Daisy Chain

KNX Bus Permanent Connections

Compliance

CE, KNX

Operating Environment