Replacement power supply
for pds-400 48v eo (16 pages)
Summary of Contents for Philips PDS-60ca
Page 1
PDS-60ca Power/data supply for indoor and outdoor applications...
Page 2
PDS-60ca Power/data supply for indoor and outdoor applications PDS-60ca is a versatile power/data supply designed for indoor and outdoor LED lighting luminaires employing low voltage luminaires from Philips Color Kinetics. PDS-60ca is available in 7.5 V and 24 V •...
211 mm (8.3 in) Classification UL Class 2 power supply and Safety Environment Dry/Damp/Wet Location, IP66 * KiNET is the Ethernet lighting protocol from Philips Color Kinetics. Ordering Information Item Item Number Philips 12NC mounting slots PDS-60ca 7.5 V DMX/Ethernet...
It is the responsibility of the contractor, installer, purchaser, owner, and user to install, statements. maintain, and operate PDS-60ca in such a manner as to comply with all applicable codes, state and local laws, ordinances, and regulations. Consult with the appropriate electrical inspector to ensure compliance.
Page 5
Refer to the table on the left for quantities of each luminaire that you can connect per PDS-60ca device. Refer to the luminaire product guides for information on electrical configuration for luminaires.
Page 6
Position the PDS-60ca device in its designated mounting location. Make sure the Make sure that the device is securely mounting location is flat, suitable for the mounting hardware, and clear of debris attached and free of excessive vibration.
Page 7
Sized for 3/4 in (19 mm) trade size conduit To add a second power/data supply to your DMX network, connect an RJ45 cable from the PDS-60ca device’s DMX OUT port to the DMX IN port on the Slave PDS-60 DMX second PDS-60ca device.
Page 8
Make sure line power is OFF before connecting luminaires to the device. On most PDS-60ca models, the luminaire ports are at the end of a short cable attached to the board adjacent to device’s data ports. (See the illustrations on the previous page.) Guide the connector and cable through an opening in the device’s luminaire...
Page 9
Produces a series of light flashes at regular Effects buttons straight On/Off and intervals on random nodes dimmed sparkle PDS-60ca Pre-Programmed has 5. White Fixed four controls that are located Color inside the device’s housing: A static display of solid white color...
Page 10
DMX addresses, one for the red channel, one for the green channel, and one for the blue channel. With PDS-60ca devices in a DMX network, luminaires are not directly programmed with DMX addresses. Instead, you use the device’s Auto Config Button to discover connected nodes and use QuickPlay Pro software to program a base light number on the PDS-60ca.
DMX OUT Power Indicators ETHERNET The PDS-60ca has two power indicators, one for each luminaire port. If a port fails OUT 1 OUT 2 for any reason (for instance, if a fuse blows), the red indicator light will be off.
DMX OUT DMX IN PDS-60ca 24 V (2) 4 A, 5 x 20 slow blow fuses PDS-60ca has a fuse for each of its ports, protecting each port from excessive ETHERNET OUT 1 OUT 2 current. Always replace blown fuses with the same rated fuse: Make sure that the device’s power is OFF.