Advertisement
MOUNTING & INSTALLATION
Installation Location:
Care should be taken when choosing the best
location for mounting the AX-DV-XP / AX-
DVF-XP. Do not install the video door station
in any areas subject to direct sunlight or other
strong direct lighting conditions; installation in
such locations may cause reduced visibility
and/or video quality while viewing from the
master station.
AX-DV-XP
AX-DVF-XP
5'
20"
Physical Mounting Instructions:
1. AX-DV-XP – provide mounting box or wall opening
sufficient for both the CAT-5e cable (from the AX CEU)
and the -XP series card reader wire pigtail (Fig. 1),
noting the offset location of the reader pigtail (Fig. 2).
AX-DVF-XP – provide wall surface opening for rough-in
backbox (supplied), using dimensions shown (Fig. 3).
Note: if surface mount is required, use the Aiphone
SBX-DVLF- (sold separately) .
2. Open
the
protective
connect the CAT-5e cable (RJ45)
from the AX CEU to the AX-DV-XP
or
AX-DVF-XP
routing the wire in one of the two
possible directions, as shown (Fig.
2). Be careful to avoid damaging the
wire
jacket
when
protective door.
3. AX-DV-XP – Secure the door station to
the wall surface using the provided
mounting screws and/or anchors, as
shown (Fig. 1).
resistant chassis using the security driver
(provided).
AX-DVF-XP – Secure the door station to
the backbox using the included security
screws / driver (Fig. 3).
6'1"
AX-DV-XP
AX-DVF-XP
2'1"
20"
3'11"
3'1"
door
and
station,
carefully
securing
the
Secure the vandal
Mounting Height & Viewing Angle:
Because the AX-DV-XP and AX-DVF-XP
contain
a
fixed-angle
mounting height and placement relative to the
entry should be taken into consideration. The
recommended
corresponding viewing angle are shown, at
left.
-XP Series Prox
Reader Pigtail
Figure 2
camera
element,
mounting
height
1-3/8"
1/4"
3"
8-3/4"
Figure 1
1-25/32"
Figure 3
and
4-1/2"
8-7/16"
Pg. 2
Advertisement
