Changing The Door Hinging - Lec CU 357 Operating Instructions Manual

GB/IE

Changing the door hinging

See figures 11-14 for instructions on how to change the door hinging.
The fridge must be off and empty.
- tilt the appliance by 45 degrees backward. Thereby, the lower hinge becomes accessible.
- use cross screw driver to unscrew the three lower hinge bolts (see fig. 11).
- remove the door and set aside. Make sure the door cannot fall.
- use screw driver to remove the pin below the control panel at the right side of the
fridge. Screw it fully into the hole at the left side (see fig. 12).
- unscrew the two lower bolts. Remove the plug from the lower hinge socket with a
screw driver (see fig. 13).
- fit the fridge door back, insert the top pin into the door slat.
- insert the hinge pin into the lower slat. Screw the hinge fully with a cross screw driver.
- unscrew the door handle (see fig. 14).
- fit the handle to the opposite side of the door.
- start the appliance according to the relevant instructions.
12
11
13
14
12