Cleaning - PowerTec TS1001 Owner's Manual

COMPOUND MITER CROSSCUTTING
0° ~ 45° BLADE BEVEL AND 0° ~ 45° MITER
GAUGE
Refer to Figure 23
1. Place the miter gauge at the right side goove of the
table and set it to the desired angle.
2. Set the blade to the desired bevel angle and tighten
miter angle lock knob.
3. Hold the workpiece against the miter gauge through the
operation.
Figure 23
0° ~ 45° MITER ANGLE
Refer to Figure 24
1. Set the blade to 0° and tighten the miter angle lock
knob. Set the miter gauge to the desired angle.
2. Holding the workpiece against the miter gauge
throughout the operation.
WARNING
Disconnect the unit from power source before serving or
disassembling any components.

CLEANING

• Keep machine and workplace clean. Avoid accumulation
of sawdust on the tool.
• Be certain motor is kept clean and free of dust.
• Use soap and water to clean painted parts, rubber parts
and plastic guards.
LUBRICATION
• All motor bearings are permanently. Lubricate at the
factory and require no additional lubrication.
• On all mechanical parts of your table saw where a pivot
or threaded rods are present, lubricate using graphite
or silicone. These dry lubricants will not hold sawdust as
would oil or grease.
Figure 24
DADO CUTS
1. A Dado table insert is included with this saw. Remove
the saw blade and blade guard. Install a Dado blade
and the Dado table insert.
2. Instructions for operating are packed with the
separately purchased Dado set.
3. The arbor on this saw restricts the maximum width of
the cut to 1/2" (13mm).
4. Make sure that the Dado nut is tight, and that at least
one thread of the arbor sticks out past the nut.
5. You must remove the blade guard and splitter when
using the Dado. Excuse caution while the Dado
is operating.
6. Check the saw to make sure the Dado will not strike the
housing, inert, or motor while in operation.
NOTE: When using the Dado blade nut slot, the Dado nut
must be used.
WARNING: FOR YOUR OWN SAFETY, ALWAYS
REPLACE THE BLADE, BLADE GUARDS ASSEMBLY,
AND BLADE INSERT WHEN YOU ARE FINISHED
MAINTENANCE
KEEP TOOL IN REPAIR
• If power cord is worn, cut, or damaged in any way, do
not operate the machine.
• Replace any worn, damaged, or missing parts. Use
parts list to order parts. Any attempt to repair motor
may create a hazard unless repair is done by a qualified
service technician.
9