System Check - LogicMark FreedomAlert 35911 Installation & Operation Instructions

System Check:

The button on the bottom of the pendant case which is used to perform the
BATTERY CHECK, will also perform a SYSTEM CHECK. Press and hold
this button for more than four (4) seconds. One of the following announce-
ments will be made.
"System check, all systems are ok."
This confirms the following:
Battery status.
The Pendant is working.
The Base unit is working.
The Base unit is connected to a working phone line.
The Pendant is within range of the Base unit.
"System cannot detect dial tone."
The Base unit is not connected to the phone line or can not get a
dial tone for some reason.
"Base and Pendant out of range."
This confirms one or more of the following:
The Pendant has malfunctioned.
The Base has malfunctioned.
The Pendant and Base unit are not communicating with each other
or are out or range.
If you receive a failure notification, please refer to the TROUBLESHOOT-
ING guide on page 21 of this manual to determine the cause.
This testing feature is very useful - allowing you to confirm that the
system has coverage from all parts of your home. Simply walk to the
various parts of your home and push the Battery Check / System Check
button until you hear the  beeps and then the dial tone. You can then
release the button, and you will hear "System Check. All Systems are
OK" voice prompt, or "Pendant and Base out of Range".
18
FreedomAlert
®
v0.2