Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for LogicMark FreedomAlert 35911
Summary of Contents for LogicMark FreedomAlert 35911
- Page 1 INSTALLATION & OPERATION INSTRUCTIONS Guardian Alert Model #35911 v0.2...
- Page 2 PLEASE READ THIS MANUAL COMPLETELY AND SAVE IT FOR REF- ERENCE. Thank you for choosing FreedomAlert ® – the most unique Personal Emergency Response System in the world, and covered by both US and Canadian patents. FreedomAlert is your personal link to Family, Friends, or Emergency Personnel when needed.
-
Page 3: Table Of Contents
TABLE OF CONTENTS Overview of the FreedomAlert .............. Contents of FreedomAlert kit ..............4 Limitation of Liability ................5 Installing the Batteries ................6 Connecting the Base Unit Power Connection ................8 Telephone Connections ..............8 How to Handle VoIP & DSL ............9 Location of Base Unit ..............10 Base Unit Options &... -
Page 4: Contents Of Freedomalert Kit
Contents of the FreedomAlert Kit: The items below are included with your FreedomAlert . Pendant Base Unit Rechargeable Li-Ion Special Pendant Batteries - Pieces Rechargeable AA Batteries - 4 Pieces Belt Clip AC Adapter Wrist / Walker / Wheelchair strap Phone Cord Screwdriver... -
Page 5: Limitation Of Liability
LogicMark LLC as a result of any cause whatsoever, regardless of whether or not such loss, damage, or personal injury was caused by or contributed to by LogicMark’s negligence to any degree or failure to perform... -
Page 6: Installing The Batteries
Rap the pendant firmly against your hand a few times to get the battery to fall out. NOTE: These white/silver batteries are very special batteries that are not available at your local store. See Specification on page 30 for more details, or contact LogicMark to purchase replacement batteries. FreedomAlert ® v0.2... - Page 7 Place the extra Pendant battery into the front charging area of the Base unit so that it will charge and be ready when its time to swap the batteries around. The LED on the right side will glow red when charg- ing and green when fully charged.
-
Page 8: Connecting The Base Unit
Connecting the Base Unit Power Connection Simply plug in the AC Adapter in to the nearest elec- trical outlet. Plug the other end of the AC power adapter into the Base unit. You need to push the plug into the opening in the Base unit and twist 90’ clockwise to lock in place. -
Page 9: How To Handle Voip & Dsl
FreedomAlert system to the traditional phone line. For more information on using the FreedomAlert product with your VoIP system, visit our website at www.LogicMark.com and view the FAQ under the OUR PRODUCTS tab. How to Handle DSL: If your home has DSL... -
Page 10: Location Of Base Unit
Locating the Base Unit: For best results and longest range, locate the Base unit in an area away from household appliances which could present electrical interference. These include microwave ovens, televisions, electric mixers or blenders, hair dryers, wifi routers or other cordless phones. Do not place on a metal surface. -
Page 11: Programming The Unit
slide the slide switch back to one of the “Friends” position. Note: Discon- necting power or changing batteries does not erase the numbers. How does the Base unit know when to go to the next number? The base unit will first dial the first number in the “Friends” list. About 20 seconds into the conversation, the Base unit will interrupt the call and announce “This is an emergency call. -
Page 12: Telephone Number Programming Worksheet
Step 1: Write out the numbers you are wanting to program into the system. Below we will refer to Number 1 as the first number, Number 2 as the second number etc. Include area-codes and a 1 or 9 if they are needed for dialing. Step 2: Establish a phone connection with a friend or family member - or with your cell phone. - Page 13 1. Completely fill out this worksheet before starting to program telephone numbers. 2. Call a friend or family member on your telephone. 3. Slide switch to LEARN MODE [voice prompt – Learn Mode] 4. Enter: 1234 [voice prompt – one, two, three, four, programming mode] 5.
-
Page 14: Adding Additional Pendants To The System
Adding Additional Pendants to the System. FreedomAlert comes with one Pendant. If you want to add additional pen- dants to your system - follow the directions here. If not, skip this section. The Pendant’s unique ID code should already be learned into the Base unit when it came from the factory. -
Page 15: Operating The Freedomalert
At a later point in time, you might want to erase your previously learned pendants. You can erase all previously learned pendants by simply holding down the red Code Learn button at the back of the Base unit for 8 seconds. You will hear the confirmation of “Previous Pendant Codes Erased”... -
Page 16: Holding The Pendant
Holding the Pendant. At this point - you simply hold the Pen- dant as you would any normal telephone receiver - close to the head so that you can hear the other person being called - and they can hear you speaking. Hanging -Up. -
Page 17: Battery Check
3 or 4 weeks before needing to be charged - it is then time to replace both the Pendant batteries. Note: This is a very unusual battery not available at most outlets. Order replacement batteries from LogicMark as directed on page 29. -
Page 18: System Check
System Check: The button on the bottom of the pendant case which is used to perform the BATTERY CHECK, will also perform a SYSTEM CHECK. Press and hold this button for more than four (4) seconds. One of the following announce- ments will be made. -
Page 19: Emergency Dialing Using The Panic Button
Caution - To ensure proper operation, this equipment must be installed according to the these instructions. We highly recom- mend that you perform this System Check after set-up and instal- lation and at least twice a month to confirm that your system is working properly and that the pendant and base unit are in good communication and that the base unit can get a dial tone. -
Page 20: Water Resistance
Water Resistance: FreedomAlert will resist occasional splashes from water - i.e as in the shower. However, it should never be submerged or exposed to water continuously. Periodic Testing / Maintenance It is highly recommended that you preform a full System Check (see page 18) at least twice a month. -
Page 21: Troubleshooting Guide
TROUBLESHOOTING GUIDE What if I can’t get the FreedomAlert to work? Step 1 – Push the gray RESET button with a pen at the back of the base unit (next to the power cord). Check the system. If it is now working skip the remaining steps. - Page 22 a wireless radio link. They must be synchronized to work together. They should have already been synchronized at the factory, but resetting this is simple. What to do: Follow the steps on page 14: Adding Additional Pendants to the System Now perform the System Check test again (page 18) to make sure all is well.
- Page 23 Information The FCC Wants You To Know: FCC ID: TYD35911 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
- Page 24 Should you experience trouble with this equipment, please contact LogicMark at 703-934-7934 for repair or warranty information. If the equipment is causing harm to the telephone network, the telephone company may request that you disconnect the equipment until the problem is resolved.
-
Page 25: General Warnings And Precautions
Base unit or the Pendant will void the warranty and may damage the unit or prevent it from working properly. 6. Do not use any power source other than that supplied from LogicMark, LLC specifically for this product. Use of any other power source could damage your unit or make it unsafe. -
Page 26: Warranty
FreedomAlert equipment. The equipment is designed to communicate with the contact list of your choice as well as emergency 911 operators and LogicMark LLC is not and shall not be responsible for ambulance, police or other emergency response time or that any response will be provided by the anyone on your contact list including the emergency 911 response center. - Page 27 LogicMark LLC’s negligence to any degree or failure to perform any obligation or strict products liability, such liability will be limited to an amount paid by the Purchaser to LogicMark LLC for the product, or to the sum of $300.00, whichever is greater.
- Page 28 OUT OF WARRANTY REPAIRS If the warranty period has expired or if you are not the original owner of the product, LogicMark, LLC will at its option either (1) replace this product with a functionally similar (but not necessarily identical) refurbished product or (2) repair the original product and return it to the original consumer/purchaser after payment of repair/replacement charges has been received.
- Page 29 Replacement Parts / Optional Accessories: Rechargable Li-Ion Special Pendant Batteries Pieces Part #5917 $15.00 Rechargable AA Batteries 4 Pieces Part #5918 $15.00 Lock Box Extra Pendants Part #091 $4.95 Part #5915 $119.95 All prices are in US dollars and include shipping and handling to the 50 United States.
-
Page 30: Product Specifications
Up to 16 Pendants can be programmed to one Base unit. Pendant Batteries 3.6 (or 3.7) volt 300 mAh Li-Ion (2 pieces) battery size 10440. Should be replaced every 2 years Purchase replacements from LogicMark Operating Temperature 32˚ to 120˚ F. (0˚ to 49˚ C). FreedomAlert ® v0.2... - Page 31 FreedomAlert ® v0.2...
- Page 32 FreedomAlert is covered by the following patents: US # 5,521,582 & Canadian # 2,080,921 Other patents pending ©2010 LogicMark, LLC FreedomAlert ® v0.2...
Need help?
Do you have a question about the FreedomAlert 35911 and is the answer not in the manual?
Questions and answers