Vidao 55V800R User Manual page 21

TV Setup
IMPORTANT NOTE: If your TV is connected to a Cable or
Satellite set top box DO NOT run the "Channel Auto Scan"
in STEP 3.
STEP 3: Setting Air/Cable and Channel Auto Scan
Note: Your type of television connection will determine if you should complete the
Channel Auto Scan part of this step.
Source Select
TV
YPbPr / AV
HDMI1
HDMI2
HDMI3
PC
Media
Setup Wizard
Air / Cable
Cable
Go to next step
Select the antenna type then auto scan
Select Move
Setup Wizard
Next
Analog :
Digital :
RF CH :
Total Found :
Use the tu arrow buttons to select Air or Cable based on your
type of connection (Antenna or Cable without a set top box).
For Cable/Satellite Connections WITH a set top box:
Press the MENU button on the remote control to exit the Setup
Wizard.
NOTE: You will see the message "PLEASE RUN AUTO SCAN"
on the screen. Ignore this message as this is not necessary
when using a set top box.
Press the INPUT button on the remote control to display the
Input Source screen illustrated to the left.
Use the pq arrow buttons to highlight the input where the
set top box was installed. Press ENTER to select the desired
input.
Initial Setup is now complete. You may now begin enjoying your
TV, or make further adjustments to the TV settings which are
explained in the following pages of this manual.
Return
MENU
For Antenna & Cable Connections WITHOUT a set top box:
Use the q arrow button to select Go to next step and press the
u button to begin the Channel Auto Scan.
Channel Auto Scan may take several minutes to complete.
0
0
Once Channel Auto Scan has ended, Initial Setup is
2
0
complete. You may now begin enjoying your TV, or
make further adjustments to the TV settings which are
Exit
MENU explained in the following pages of this manual.
Initial Setup Wizard
55V800R-20