LG 26LH1DC3 Installation And Operating Manual page 72

APPENDIX
CLONING PROCEDURE TROUBLESHOOTING
Clone not working
Clone programmer problem.
Clone Scans Channels more than once.
Clone should only scan
channels once.
Master and Other 26LH1DC3/4/5
Cloning did not work.
Procedure interrupted.
Different TV models.
Step(s) omitted or not
performed.
Insufficient cloning time.
Cloning erratic.
Clone time disappeared.
Batteries were removed.
New Setup not present
26LH1DC3/4/5 not reset.
• After cloning operations are complete, just unplug the LT2002 from the 26LH1DC3/4/5.
• If the 26LH1DC3/4/5 does not display a picture on the TV (blank screen) after a few seconds, just change channels.
72
Try a different LT2002 Clone programmer.
8
Reset Clone Programmer.
8
Retry cloning again.
8
Wait until procedure complete message is displayed.
8
Cloning is only possible with identical model TVs.
8
Reread 54 - 55 - 56 pages to be sure all tasks were performed.
8
Redo cloning and be sure learning/teaching time is about 1 min. and 5 to15 seconds (75 seconds).
8
Reset Clone Programmer.
8
Batteries must remain installed to retain time settings.
8
Disconnect newly cloned unit from power for 5 seconds.
8