Commercial Mode; Installer Overview - LG 26LH1DC3 Installation And Operating Manual

COMMERCIAL MODE

INSTALLER OVERVIEW

Following is the Commercial Mode Operation Setup.
Operating Installer Menu
To set up the controls for the TV you will need to know how to enter
the 26LH1DC3/4/5 Installer menu and make changes to the default
values as required. If necessary, familiarize yourself with the 26LH1DC3/4/5
Installer menu and how to make and save changes in the menu.
Optional Installer Remote
You will need an Installer remote control similar to the one shown to the
right.
The TV's clonable features need to be set up before 2-5-5 + Menu is
done.
This is a critical step.
If the Master TV display panel's clonable features like: Clock Set, adding
channel icons and channel labels, etc. are not done properly, then the
cloned 26LH1DC3/4/5 TVs will all have problems. For example, do not do
2-5-5 + Menu more than once or the TV setup will become corrupted. If
you need to start the procedure over, then begin by setting installer item
1 17 to 001, and pressing Enter to reset the TV to default values in the
installer menu. You can do 2-5-4 + Menu mode more than once but this
mode is limited to only editing channel icons and channel labels.
Refer to the appropriate section in the Manual for other TV features:
Picture, Sound etc.
Digital Font options are available only after a channel search has
*Note:
been run and when the TV is tuned to an active digital channel with digital
captions.
LT2002 Clone Programmer
As the cloning procedure is being performed, specific steps need to
¤
QuickSet II Programmer
LT2002
52
be done at the indicated times to achieve the
desired result. Be sure to do each cloning task as
indicated. If a procedure or step is left out or not
performed correctly, then the TV setup will be wrong
and cloning may not work. At each step, pay
attention to assure the TV screen shows the proper
message(s) when cloning. If the message indicated
does not appear, there is a problem with that step
and cloning may not be successful. Cloning is only
possible when the signal source is an Analog channel,
not a digital channel.
LODGING PTC INSTALLER MENU
000 INSTALLER SEQ 000
UPN 000-000-000-000 FPGA 09F1
PTC V1.00.000 CPU V1.01.00
Typical Installer Menu