Maintenance - IKH XTP6 Instruction Manual

9. When tilling in hard soil, gradually try the tilling depth from shallow to deep.
10. When turning, push down on the handlebars to bring the tiller's weight to the rear; this will
make turning easier.
11. Carefully squeeze the clutch lever to adjust the forward speed.
12. Release the clutch lever and turn off the engine after operation or in the intervals.
13. To move the tiller, put the front wheel in the "down" position. It is much easier in the soft soil
to pull the tiller out on the handlebars than to move the machine forward. When pulling the
machine, remember to lift up the handlebars and make sure tines is away from the ground.
14. To make the working width to be 75cm, take off the left rear disc and right rear disc. Then
attach the 2 additional tine assemblies to the tine shaft. And fasten the 2 rear wheels with clamps.
Please refer to figure 1 and the exploded drawing attached.
15. To reverse the tiller, please loose the forward handle, and fasten the backward handle.

MAINTENANCE

Please note the maintenance applies to normal operating conditions. If you operate the tiller under
different conditions, we recommend you to consult your local dealer for the maintenance.
1. Turn off the engine and disconnect spark plug before maintenance.
2. Let the engine and exhaust system cool down to avoid being burns from hot parts.
3. Wear safety gloves in case you may get injury by some sharp edge.
4. Clean the soil adhesive to tines and spread anticorrosive oil on.
5. Drain out all the fuel and oil from the machine if the storage is supposed to more than one month.
6. The items listed in the below should be serviced by a professional.
Picture 4.
1. Spring clamp 2. Retainer 3. Drag bar