Advertisement
Step 2
Remove the connector cover from the side of the camera.
z
Disconnect the ALC lens connector of the camera and open the slide cover.
x
Remove the screw securing the connector cover and remove the connector cover from the
camera body.
c
Place the slide cover back after removing the connector cover.
Note:
• The removed screws that
secured the connector
cover will be reused in
Step 8.
• Please store the removed
connector cover in a safe
location for when you
choose to remove the IR
LED unit, as it will not be
needed from this point
onwards.
Step 3 Attach the safety wire to the safety wire lug (camera
accessory).
Attach the safety wire (camera accessory) to the safety wire lug (camera accessory) according to
the following illustration.
Part A
Safety wire lug
(camera accessory)
z
Pass part A through the
wire engaging hole
6
Slide cover
Connector cover
Screw
lens
ALC
connector
Safety wire (camera accessory)
Wire engaging hole
x
Pass part A through the
other loop of the wire
After mounting
Advertisement
