Some Typical Cleaning Tasks - Wilhelmsen Ships UNTIOR HPC 54/1 Instruction Manual

UNITOR HPC 54/1 67/1
5.2

Some typical cleaning tasks

Task
Cleaning of
walls, floors and
equipment.
Detergents
Machinery
5.2.2
Task
18
Accessories
1. Soaking – apply foam to all surfaces (bottom to top)
Injectors
Foam lance 2. Remove the dirt from surfaces with the high
Powerspeed lance
Floor Cleaner
3. To flush away large quantities of dirt, change to low
l
4. Use recommended disinfectant products and
Detergent injection 1. Apply detergent to vehicle or equipment surfaces in
Powerspeed lances
Curved lances and
underchassis washers 2. Proceed with cleaning using the high pressure
Brushes
3. Clean fragile areas such as motors, rubber at lower
Accessories
Method
and wait for approx. 10 - 30 minutes.
pressure lance or chosen accessory. Again, clean
from bottom to top on vertical surfaces.
pressure mode and use the higher flow to push
away the dirt.
methods to ensure hygiene. Apply
disinfectant once the surfaces are perfectly clean.
order to soften up dirt and grime. Apply from bottom
to top.
lance. Clean again from bottom to top. Use
accessories to clean in difficult to reach places.
pressure levels to avoid damage.
Method
1)
Options / model variants
Original instructions